Check Point Smart-1 - For Windows XP Operating Systems; For Windows 7 and Windows Vista Operating System

3
Figure 1: Internet Protocol (TCP/IP) Properties
For Windows XP Operating Systems
• Click
> Settings > Control Panel
> Network Connections.
• Double-click
Local Area Connection.
• In the General tab, click Properties.
• In the IP address field, enter
192.168.1.2.
• In the Subnet mask field, enter
255.255.255.0.
• Leave the Default gateway and
DNS settings fields empty.
• Click OK and close the
dialog boxes.
Figure 2: Internet Protocol (TCP/IP) Properties
For Windows 7 and
Windows Vista Operating System
• Click
> Control Panel
> Network and Internet
> Network and Sharing Center
> Manage network connections.
• Right-click Local Area Connection,
and then click Properties. If you
are prompted for an administrator
password or confirmation, type the
password or provide confirmation.
• Click the Networking tab.
Under This connection uses the
following items, click Internet
Protocol Version 4 (TCP/IPv4),
and then click Properties.
• In the IP address field, enter 192.168.1.2.
• In the Subnet mask field, enter 255.255.255.0.
• Leave the Default gateway and DNS settings fields empty.
• Click OK and close the dialog boxes.