Cherry 8000 series - Programming Examples

4.4 Programming examples
Examples for barcode
programming
Example 1:
Setting barcode options to default.
For setting the barcode options to default
status proceed as follows:
1. Press the six mode keys (SHIFT left,
SHIFT right, CTRL left, CTRL right, ALT
left, ALT right) for at least 3 seconds to
enter the programming mode
(Keyboard beep, menu entry on
screen).
2. Press the “R”-key.
3. Press the “6”-key
4. Press the Space-key to exit the
programming mode.
Example 2:
Enable/Disable Code 39 decoding
(via keyboard). To enable/disable the
barcode CODE 39 proceed as follows:
1. Press the six mode keys (SHIFT left,
SHIFT right, CTRL left, CTRL right, ALT
left, ALT right) for at least 3 seconds to
enter the programming mode
(Keyboard beep, menu entry on
screen).
2. Press the “A”-key.
3. Press the “1”-key.
4. Press the “Y”-key to enable the
decoding of Code 39. If you would like
to disable the decoding press the “N”-
key.
5. Press the Space-key to exit the
programming mode.
Example 3:
Define and Enable barcode header 1. To
define and enable a barcode header
proceed as follows:
1. Press the six mode keys (SHIFT left,
SHIFT right, CTRL left, CTRL right, ALT
left, ALT right) for at least 3 seconds to
enter the programming mode
(Keyboard beep, menu entry on
screen).
2. Press the “Q”-key.
3. Press the “3”-key.
4. Type in the keystring you like to
program (e.g. “BH1”). To finish the
string press the Enter-key at the
numeric key pad.
5. Press the Space-key to exit the
programming mode.
Example 4:
Define and Enable barcode terminator 1.
To define and enable a barcode
terminator proceed as follows:
1. Press the 6 mode keys (SHIFT left,
SHIFT right, CTRL left, CTRL right, ALT
left, ALT right) for at least 3 seconds to
enter the programming mode
(Keyboard beep, menu entry on
screen).
2. Press the “T”-key.
3. Press the “3”-key.
4. Type in the keystring you like to
program. To finish the string press the
Enter key at the numeric key pad.
5. Press the Space-key to exit the
programming mode.
Examples for magnetic card
reader programming
Example 1:
Enable/Disable magnetic card reader
track 1 decoding.
To enable/disable the magnetic card
reader proceed as follows:
1. Press the six mode keys (SHIFT left,
SHIFT right, CTRL left, CTRL right, ALT
left, ALT right) for at least 3 seconds to
enter the programming mode
22
644-0130.03 e,ch 17.07.2001 7:35 Uhr Seite 22