To Next PageTo Next Page
Need help?Do you have a question about the CHERUBINI Wave RX and is the answer not in the manual?
Explanation of symbols used to represent button presses and motor actions.
Time limit for setting the first remote control after power connection.
Step-by-step instructions for setting the motor's closing limit position.
Step-by-step instructions for setting the motor's opening limit position.
Instructions to remove the programmed closing limit switch setting.
Instructions to remove the programmed opening limit switch setting.
Method to erase all programmed limit switch positions from the motor.
Steps to remove a previously memorized middle position.
Instructions for setting the motor to its maximum torque, only for motors from 32 Nm.
Procedure to delete individual remote controls or channels from the motor's memory.
Steps to clear the motor's memory using a remote control.
Emergency procedure to clear memory by wiring the white wire.
Using a middle position with light automation from WindTec Lux sensor.
Procedure to program a custom additional middle position activated by light sensor.
Steps to cancel a previously programmed additional middle position.
Temporary remote control storage for assembly or setting, lasting 5 minutes.
How to individually delete buttons programmed on the A530058 pocket remote.
Initial steps to activate the fabric tightening function.
Adjusting and confirming the desired fabric tensioning position.
Procedure to remove the programmed fabric tightening position.
Activating/deactivating high sensitivity obstacle detection during downward movement.
General
