Please take care to properly use
the compressor gun while
fueling.
The compressor gun shall be fully
inserted into the fuel tank. Do not
tilt the gun against the filler
opening.
If the automatic compressor gun
is applied, it indicates that the fuel
tank is refilled up once the
compressor gun closes
automatically while refueling. In
this case, be sure not to try to
refuel continuously, otherwise
there is no expansion space inside
the fuel tank. The fuel will spill
over from the fuel tank once the
temperature rises.
Please take care to screw up the
tank cap after refueling.
Please take care to abide by the
local related laws and regulations
when you carry the spare canned
fuel with your vehicle
For the sake of safety, it is
recommended that you don’t
carry the spare canned fuel with
your vehicle in order to avoid that
the fuel tank is damaged and the
fuel spills over to result a fire
disaster when a traffic accident
occurs.
Replace the lamp bulb
Unless it is a very emergent case, it is
unallowable for an owner
himself/herself to replace the bulbs of
the headlamp group since the front
bumper shall be removed before these
bulbs are replaced. However, it may
cause great trouble when no tools are
available. If the replacement is
necessary, the light/lamp and the
ignition switch must be turned off
before any bulb is replaced.
DO NOT directly hold the bulb glass
with the fingers, otherwise the
fingerprint upon it will be heated and
volatilizes when the headlamp turns on,
and deposits on the mirror surface,
which will darken the reflector.
During the replacement of any bulb,
make certain that the same model of
bulb is applied. Please review the bulb
specification before installation.
To Next Page
Loading...
