Instrument Panel
52
Warning devices
The warning devices are used to show
driver the traveling condition of the
vehicle and whether the vehicle has
gotten problems which can cause serious
damage and harm to the vehicle. If some
one system has trouble, its corresponding
warning light will light or flash.
When the ignition switch turns on, a
majority of warning lights will light for a
short time to perform the system
self-checking. If a certain warning light
does not light, or it still lights or flashes
continuously after the engine has started,
please drive your vehicle to the CHERY
Authorized Service Station to make the
related system repaired.
Low fuel indicator lamp
When the level of fuel in the fuel tank is
below 10 liters, this lamp lights and give
an alarm, and the pointer of the fuel
gauge will point to the red alarm line.
When the indicator lamp lights, please
refuel as soon as possible.
ABS Warning light
In case that the ignition switch turns on,
this warning light will light for a short
time and the ABS system will perform
self-checking at the same time and
determine whether the system is in good
condition. If this warning light
continuously light or flash after the
ignition switch turns on or during the
traveling of vehicle, it indicates that this
ABS system has trouble. However, the
vehicle still has the general braking
ability (without ABS) unless the brake
system warning light also lights. In this
case, please drive your vehicle to the
CHERY Authorized Service Station to
make it repaired A.S.A.P. However, you
should drive carefully and don’t drive at
high speed. Please refer to ―Brake‖ for
the precautions on the use of ABS
system.
To Next Page
Loading...
