ignition switch turns on. The light will
keep lighting to remind that the
passengers shall wear their seat belts.
This light extinguishes after wearing the
driver-side seat belt.
Fasten the seat belt
Pull out the belt smoothly and steadily.
The belt may be locked if the pulling
force is too large or the vehicle is in a
slope. The seat belt shall be placed on the
center of your outside shoulder. The
waist part of the belt shall adhere to your
hip tightly other than your stomach.
To release the seat belt, press the red
button on the belt buckle and smoothly
retract the belt.
Make sure that each seat belt is equipped
with a proper belt buckle.
Two-point seat belt at the
center of rear seat
The length of this seat belt can’t be
adjusted automatically. During the use of
the belt, insert the tongue plate into the
clamp until you hear the click sound, and
then manually adjust its length to make
the belt tightly contact your hip.
Maintenance of seat belt
Seat belt check
If it is difficult to pull out the
belt, please pull it once by
force and then release it. To
do so, the seat belt can be smoothly
pulled out.
To Next Page
Loading...
