EasyManua.ls Logo

Chery QQ6 - Engine Coolant Reservoir

Chery QQ6
169 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Maintenance and Care
133
DO NOT dispose the empty oil
container as the domestic waste.
In case of the disposal of these
containers, please utilize the local waste
treatment facilities qualified.
Brake fluid
The brake fluid reservoir is located at the
right rear portion of engine compartment.
The fluid level must be between the MIN
and MAX marks at the side of the fluid
reservoir. If the fluid level falls down to
the MIN mark, the brake fluid level
warning light will light.
Refill the brake fluid conforming to the
CHERY’s specification only. Refer to
Capacity and Specification Parameters
in this manual. Get to the CHERY
Authorized Service Station to check the
leakage of this system A.S.A.P.
In case that the brake fluid is refilled,
make certain that it is absolutely clean.
Engine coolant reservoir
QQ6 engine has a main radiator and an
auxiliary radiator. When refilling the
coolant, pay attention to the following
methods:
Method to refill the coolant at the filler
cap: In case of the engine’s cold state and
standstill, turn the filler cap in the
clockwise direction and apply the
pressure on the cap to open it, and then
refill the coolant until it can be seen
viewing from the filler opening. Tighten
the filler cap in the anticlockwise
direction, start up the engine and let it
operate at the idle speed for about 1
minute, and then shut down the engine.
Open the filler cap and continuously refill
the coolant until it can be visiable
viewing from the filler opening.
In case that the engine’s water
temperature is high or in case of each
maintenance, note that the coolant is
refilled in time from the filler cap.
Please DO NOT let the brake
fluid contact your skin or
eye(s). If this accident
occurs, please wash the affected
position with a lot of clean water and
immediately go to sea a doctor.
When the fluid contacts the
paintwork, please wipe it
with the wet sponge or wash
the paintwork with a lot of clean water.

Table of Contents

Related product manuals