Chery QQ6 - Start the Engine

Driving
36
5. Turn the ignition switch to the
―Ⅱ‖ position other than the (III).
If it needs great effort to turn the key,
you can turn the steering wheel
leftwards and rightwards until the key
can be turned freely. This may be
conducted by the following several
reasons:
 The front wheel deflects.
 The front wheel touches the curb.
 The steering wheel is turned when
you go abroad or get down. (The
steering wheel self-locks).
6. Turn on the ignition key, and, at
the same time, confirm that the
instrument panel warning lamp
lights for a short time. If the lamp
doesn’t light, it is required to get
to the Chery Authorized Service
Station to make your vehicle
required.
Start the engine
1. Turn the ignition switch to the
―Ⅲ‖ position, DO NOT step on
the accelerator pedal, and release
the key immediately after the
engine starts. In this case, the key
returns back to the ―II‖ position.
2. If the temperature is more than
-12C and it is difficult to start
the engine within 5 seconds for
the first start, then you shall turn
the key to the OFF position and
wait for 10 seconds to have a
retry.
3. If the temperature is less than
-12C and it is difficult to start
the engine within 5 seconds for
the first start, then you shall turn
the key to the OFF position and
wait for 10 seconds to have a
retry. If the engine fails to start
twice continuously, you can step
on the gas pedal to the extreme
and keep this position, and then
turn the key to the START
position. After the engine starts,
release the key, and then release
the accelerator pedal slowly as
the engine speed increases.
4. After the engine starts, it operates
for several seconds at the idling
speed, and then you step on the
foot brake, release the handbrake
and shift to a drive gear to
If the driver’s safety belt is already
fastened tightly before the ignition key
turns on, the safety belt warning lamp
doesn’t light.