direction from the surface of tail
lamp, pull out the harness
connector from the tail lamp, and
then take off the tail lamp.
2. Unscrew the protective cover of
the bulb in the anticlockwise
direction according to the
position as shown in the figure.
3. Pull out the harness connector
from the bulb, press downwards
the clip of bulb holder by hand to
make the clip go across the
locating groove and then separate
the clip to both sides, take out the
bulb and pay more attention to
the locating mark of the bulb.
4. CAUTION: DO NOT tauch the
surface of new bulb by hand so as
to avoid the influence on the
brightness of bulb. The lighting
system is a safety part. Please
note that any detailed operation
shall be correct when
replacement. If necessary, please
get to the CHERY Authorized
Service Station to make it
repaired.
It is difficult to replace the bulbs of rear
position and stop lamps. If these bulbs
have some troubles, please get to
CHERY Authorized Service Station in
time to make these lamps repaired.
High mount stop lamp bulb
It is difficult to individually replace the
stop lamp bulb. Please get to the
CHERY Authorized Service Station in
time to make it repaired.
License plate lamp bulb
Installation position: over the license
plate.
1. Unscrew and remove the tapping
screws used to fix the license
plate lamp.
2. Pull out the lamp holder and then
draw out the damaged bulb.
3. Install a new bulb into the lamp
holder and then install the lamp
holder.
4. Secure the license plate with
some tapping screws.
To Next Page
Loading...
