Check the wiper blade
Slide the tip of your finger on the edge of
a wiper blade to check the roughness of
the blade. The butter, silicone resin and
fuel may enable the wiper blade not to
normally work. It is recommended that
the glass cleaning fluid is applied to clean
the wiper blade.
Replace the wiper blade
Lift the wiper arm and make it
perpendicular to the wiper blade. To
remove the wiper blade, press down the
retaining clip according to the arrow as
shown in the figure, loosen the wiper
blade and then pull out the wiper arm in
the reverse direction.
Tire
For the sake of your safety, when
refuelling, please check the air pressure
of tires (including the spare tire) after the
tire cools. Refer to the ‖Capacity and
Specification Parameters‖ in this manual
for the recommended tire pressure.
Follow the correct tire pressure in case of
high load and driving at high speed. The
shortage of tire pressure may reduce the
stability, increase the rolling resistance,
and quicken the wear of tire, which may
result the traffic accident and injured.
If you have to drive your vehicle on the
edge of a road, you slowly drive it only.
If possible, the wheel shall be
perpendicular to the edge of road and
approach the edge. Avoid the erected and
sharp-edged obstacles. Pay attention not
to scratch the side wall of tire when you
are stopping your vehicle.
Regularly check whether there are
scratches, foreign materials and uneven
wear in the surface of a tire. The uneven
wear of tire tread indicates the wheel
related is not properly aligned.
To Next Page
Loading...
