Chery QQ6 - Page 24

24
avoid damaging the engine and the
engine flywheel.
If failing to start, the ignition key must
be turned back to the B position prior
to restart, and then be turned to this
position. After the completion of
startup, release the key and then it will
rebound to the II position.
Horn
Press down the button on the
steering wheel to operate the horn. You
also can operate the horn even when
the ignition switch is in the OFF state.
Windshield Wiper &
Washer System
The following functions are available
only when the ignition switch is turned
on. There are four operational positions
in total which shall be in OFF position
in case that the wiper is out of service.
Once the engine starts up,
the key shall be released
immediately. DO NOT stay
on the III position for a long
time.
In the cold seasons, you shall
check whether the wiper
blade is frozen on the
windscreen prior to the use of wiper. If
the blade is frozen on the windscreen,
the wiper can be used only after the
ice-out of blade. Otherwise, it may
damage the motor of wiper.
It also may damage the motor of wiper
if you operate the wiper when there are
some obstructers on the windscreen,
such as snow cover.
Please clear the obstructers before you
operate the wiper.
DO NOT operate the wiper on the dry
windscreen, otherwise it may scratch
the glass and result in the permanent
damage to the wiper blade.