28 s.
Replace the battery of
remote controller
If the coverage of remote controller
reduces gradually, replace the battery
(battery type: 3V CR 2032).
The battery is replaced according to the
following procedures:
1. Open the remote controller unit
from the side fastener with a flat
head tools.
2. Carefully unclench and take off
the battery. Install a new battery
on the position between two
contacts with the symbol (+)
facing upward.
3. Reinstall the remote controller
unit in the reverse order of
removal.
The lithium battery can’t be
disposed as the common domestic
wastes. Please dispose the used battery
in accordance with the regulations on
environmental protection.
Electronic anti-theft system
The electronic anti-theft system is
directly engine-oriented, which
considerably improves the complete
safety of vehicle theft prevention.
The chip, built in each key, integrates
the key, electronic anti-theft equipment
and engine computer into one entity,
which forms an active theft preventive
system. If one person has made one key
matching with the vehicle key in the
shape without the permission of the
owner while this key has no chip
containing information the same as the
anti-theft equipment and engine
computer, the engine cannot be started
by using this key, which reduce
probability of the vehicle loss.
In the event that you have lost your
The anti-theft system can
enter into the anti-theft state
only while all the doors,
engine hood and trunk lid fully close.
After the body is in the normal
anti-theft mode, ① four doors are
locked; ② the anti-theft indicator
light in the front of instrument panel
continuously flash.
To Next Page
Loading...
