when the head restraint is reassembled,
the head restraint of front/rear seat shall
be differentiated firstly (the head restraint
of front seat is big while the head
restraint of rear seat is small), and then
push the pin of head restraint into the
guide member until the spring clamp on
the guide member engages with the pin
properly.
Rear head restraint
The adjustment method of rear head
restraint is the same as that of front head
restraint.
Rear seat
Fold the rear seat
Pull upwards the ―ring-pull‖ shown in
the figure, and then fold the rear backrest
in the direction of arrow as shown in the
figure.
Return the rear seat
Lift up the seat backrest in the direction
as shown in the figure. DO NOT apply
too big force so as to avoid the damage
of angle regulator of seat backrest.
CAUTION: DO NOT
remove the head restraint
or adjust it too low for fear that your
neck is injured due to the shortage
of supporting your head when an
impact accident occurs. The head
restrain shall be adjusted to its
proper position.
To Next Page
Loading...
