Chery S18D - Chapter VII Removal and Installation of Instrument Panel & Instrument Panel Crossbeam; Removal of Instrument Panel

Chery S18D Service Manual
1.3. Pull off the connector of ECU wiring harness
and instrument panel wiring harness.
1.4. Remove the connector of instrument panel
wiring harness and engine wiring harness.
1.5. Remove the connectors of A/C wiring harness
and ceiling wiring harness; remove all ground
points of instrument panel wiring harness.
1.6. Remove the fixing bolt of anti-theft controller
with 10# socket wrench, and then remove its
connector.
1.7. Remove the fixing bolt on two ends of
instrument panel crossbeam with 10# socket
wrench.
Torque: 25±2N.m
46