Chery S18D - Installation Procedure

Chery S18D Service Manual
1.8. Remove the two fixing nuts between the
instrument panel cross beam and steering
column with 13# socket wrench.
Torque: 23±2N.m
1.9. Remove the three fixing bolts connecting
instrument panel cross beam top cover and
vehicle body with 10# socket wrench.
Torque: 25±2N.m
1.10. Remove the four bolts on the lower fixing
points of middle support on instrument
panel cross beam with 10# socket
wrench.
Torque: 7±1N.m
1.11. Take out the instrument panel cross
beam (Pay attention to the ground point
connected with floor).
2. Installation Procedure
The installation procedures are reverse to those
for removal.
47