Chiltrix CX34 - Page 27

Chiltrix Inc. www.chiltrix.com
Onboard External relay Control – Cont’d
Once the relays are wired as shown, the CX34 DIN setting must be changed
Disabling DIN6 & DIN7 will allow the standard CX34 controller and/or Psychrologix Controller to override
the relays
The switch status can be displayed in the C parameters
C63 is DIN6 AC heating switch mode status; 0=OPEN; 1=CLOSE
C64 is DIN7 AC cooling switch mode status; 0=OPEN; 1=CLOSE
NOTE: Using this relay control option will override inputs from the Chiltrix standard wired
controller and/or Psychrologix controller until DIN 6/7 is restored to its disabled setting.
See the Psychrologix manual for important additional information if this applies to you.
Timers as explained elsewhere in this manual will NOT be available when relay control is
used.
27