Chiltrix CX34 - Safety and Handling; General Safety Precautions; Transport and Storage

Chiltrix Inc. www.chiltrix.com
IMPORTANT NOTE – MAKE SURE TO PROVIDE YOUR DESIGN DRAWING FOR APPROVAL BEFORE GETTING
STARTED, INCLUDING DESIRED OPERATING TEMPERATURES.
Safety Precautions
NOTE: It is required to read the Safety precautions in detail before operation. The precautions listed below
are very important for safety, please follow all safety precautions.
General
•Make sure that the ground wire in the building is securely connected to earth.
• Wiring tasks should be carried out by qualified electricians only, in addition, they should check the safety
conditions of power utilization, for example, verify that the line capacity is adequate, and the power cable
isn’t damaged.
• Users must not install, repair or relocate the unit. Improper procedures might lead to accidents e.g.
personal injury caused by fire, electrical shock or unit's falling off its base, and water leaking into the
machine. Please contact a professional service department if problems arise.
• The unit shall not be installed at a spot with the potential hazard of leaking flammable gas. If gas is leaking
near the machine, there might be the risk of explosion.
• Make sure that the foundation of the unit is stable. If the foundation is unstable, the outdoor unit may
come loose from its base and cause injury.
• Make sure that the GFCI installed at the service panel is working properly to avoid shock or fires.
• If any abnormity occurs in the unit (such as a burning smell is noticed inside the unit), cut off the power
supply immediately, and contact a professional service department.
• Please observe the follow items when cleaning the unit. Before cleaning, shut off the electric supply of the
unit first to avoid injuries caused by the fan operation.
• Do not rinse the unit with water because the rinsed unit may cause electric shock.
• Make sure to shut off the electric supply before maintaining the unit.
• Please do not insert fingers or sticks into air outlet or air inlet.
Transporting and storage
The machine must be transported and stored vertically at all times
3