Chiron Iris Touch 600NG - Page 31

IRIS Touch Engineering Manual Version 1.4 Page 31 of 40
Reflash
The option will be given to reflash the unit to the latest version available from the Chiron reflash server.
On first entry to the reflash option, which could be during installation or maintenance, the password will need to be
changed as required for EN50136-2.
Otherwise you will be asked to enter the reflash password that has been configured for this unit.
A reflash to update the IRIS Touch dialler to the latest software version can be initiated and the options are shown
below:
Reflash Password
This password can be changed again if required with this setting.
Reflash IP Address
The default reflash IP address is the Chiron reflash server setup on an IP address 195.59.117.164 which is available
24/7 for connections, and kept up to date with the latest software available.
There are cases where a customer will only open their network to communicate back to the monitoring centre
(network/IP address), and in some cases the monitoring centre has their own reflash server installed. This option
allows the sending of a reflash request to an alternate IP address.
Reflash Now
Initiate the reflash to the reflash IP address and will bring up a status window to indicate progress.
Test
The test menu allows checking of all current enabled communication paths, and will test both polling and alarms.
There are two options here and these are detailed below:
Test
This will start the polling and alarm tests over the enabled communication path or paths.
Once the tests are complete the following possible outcomes are available as shown in the table on the next page.
Start GPRS/3G Fault Test (IRIS Touch 600NG or 640NG)
This option enables an engineer to simulate a GPRS/3G fault so the monitoring centre can check that the report is
presented properly to the operators.
Note: This mode stays operational for 1 minute and is then automatically switched off, to prevent a situation
where the installer forgets to switch it off thereby disabling GPRS. It can be switched off earlier if required.