Chord Hugo M Scaler - Dismantling & Radio frequency interference

Chord Electronics
Hugo M Scaler | Manual
_
7 // 30
There are no user-
serviceable components
within the Hugo M Scaler
or its power supply. Dangerous
voltages/currents exist within
the Hugo M Scaler and its power
supply, posing a severe risk of
electrocution and/or fire.
Never attempt to
open, dismantle or
apply internal third-
party devices to it or insert
anything other than the listed
interconnects or headphone
adapters within this user manual.
If the Hugo M Scaler develops a
fault or the casework becomes
damaged, immediately
disconnect from the mains
power supply and connected
equipment, and contact Chord
Electronics for further advice.
1.1 Introduction
1.2 Protection against
liquids & heat
1.3 Dismantling & radio frequency
interference
1.4 Connecting your equipment
Dismantling & radio
frequency interference
1.3
With a thick, solid aluminium
chassis, the Hugo M Scaler’s
casework largely protects the
sensitive internal circuitry from
radio frequency interference.
However, for optimal
performance, it is recommended
that the following points are
observed:
1. Consider placing the
Hugo M Scaler away
from wireless routers.
2. Separate the Hugo M
Scaler from amplifiers
using toroidal
transformers.
3. Operate mobile
phones at a distance to
avoid interference.
Although the Hugo
M Scaler is largely
shielded, it can generate
radio frequency interference
that may have an eect on radio
and television reception. If this
occurs, please reconsider your
placement.