EasyManuals Logo

Chord Hugo M Scaler User Manual

Chord Hugo M Scaler
30 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
Chord Electronics
Hugo M Scaler | Manual
_
Before connecting the Hugo M
Scaler to any equipment, consult
the manufacturer’s user guide to
confirm
compatibility.
When connecting the Hugo M
Scaler to any equipment, make
sure that all devices are o,
including the Hugo M Scaler.
Once connected, switch all
equipment on starting with
the source and ending with the
amplification.
Initially, operate the any
connected equipment on its
lowest gain setting and lowest
volume setting, gently increasing
to a comfortable listening level.
Never operate connected
equipment to the Hugo M
Scaler at excessive sound levels;
permanent hearing damage and
loss can occur.
The included 15V 4000mA
power supply simply plugs into
the Hugo M Scaler.
If the power supply is
prematurely disconnected Hugo
M Scaler may still remain active
for up to 15 seconds, however,
this may cause damage to
connected equipment.
1.1 Introduction
1.2 Protection against
liquids & heat
1.3 Dismantling & radio frequency
interference
1.4 Connecting your equipment
Connecting your equipment 1.4
Never disconnect the
power cable during
operation. Only
disconnect when Hugo M
Scaler is o. If the power
cable is disconnected during
operation there is a risk
of damage to connected
equipment.
8 // 30

Other manuals for Chord Hugo M Scaler

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Chord Hugo M Scaler and is the answer not in the manual?

Chord Hugo M Scaler Specifications

General IconGeneral
BrandChord
ModelHugo M Scaler
CategoryMedia Converter
LanguageEnglish

Related product manuals