Chord Hugo M Scaler - Setting up Hugo M Scaler; Placement

Chord Electronics
Hugo M Scaler | Manual
_
Whilst the Hugo M Scaler
operates normally within a stack
of Chord Electronics Table Top
(TT) components, such as the
Hugo TT 2, it is recommended
that you allow the device to
breathe. Allocating 10cm of
space around it to convection-
cool during operation is advised.
If possible, do not place the
unit(s) inside a cabinet.
As the infra-red remote
control requires a
direct line of sight to
the viewing portal, please avoid
placing objects in front of either
device.
4.1 Placement
4.2 Connecting an input to
Hugo M Scaler & input
selection
4.3 Connecting Hugo M Scaler
to Hugo TT 2
4.4 Connecting Hugo M Scaler
to another DAC
4.5 Output sample rate settings
Placement 4.1
19 // 30