Chord Electronics
Hugo M Scaler | Manual
_
Using the supplied BNC cables, it
is simple to connect the Hugo M
Scaler to the Hugo TT 2:
1) Turn o the Hugo M Scaler,
Hugo TT 2 and any other
connected equipment
2) Locate BNC Output 1 on the
Hugo M Scaler and connect
to BNC Input 1 on Hugo TT 2
3) Locate BNC Output 2 on the
Hugo M Scaler and connect
to BNC Input 2 on Hugo TT 2
4.1 Placement
4.2 Connecting an input to
Hugo M Scaler & input
selection
4.3 Connecting Hugo M Scaler
to Hugo TT 2
4.4 Connecting Hugo M Scaler
to another DAC
4.5 Output sample rate settings
Connecting Hugo M Scaler
to Hugo TT 2
4.3
21 // 30
OPT OUT
S/PDIF
DUAL BNC OUT
1
4) Turn on all equipment,
including the Hugo M Scaler
and Hugo TT 2
5) Cycle through the inputs on
Hugo TT 2 until ‘DBNC’ is
displayed
6) Connect the output of the
device you wish to play music
from to the digital inputs of
the Hugo M Scaler
7) Initiate playback
2
To Next Page
Loading...
