Chord ULTIMA PRE - AV Bypass & Monitor

Chord Electronics
ULTIMA PRE | Manual
_
AV Bypass mode allows the
output of an AV surround sound
processor to be connected and
then routed directly to the output
of the ULTIMA PRE. The volume
control and signal processing are
bypassed so that the signal from
the AV processor reaches the
power amplifier exactly as if it
were connected directly.
This has the advantage of
allowing the ULTIMA PRE to
remain in an AV system to
give the best possible stereo
two channel playback whilst
still being able to switch to
AV bypass mode to allow
the processor to playback
multichannel film content.
An AV Bypass Monitor output is
provided to check signal integrity
or to connect to another AV
processor.
5.1 Basic navigation
5.2 Volume and balance control
5.3 Display
5.4 Recording
5.5 AV Bypass & Monitor
5.6 EQ Frequency
AV Bypass & Monitor 5.5
30 // 34
Note: The volume control in the
ULTIMA PRE will be bypassed so
please check before switching
on your AV processor that the
volume is turned down. When
switching back please check that
the volume on the Ultima Pre has
not inadvertently been turned up
before playing any music.