Chord ULTIMA PRE - Input Gain Adjustment

Chord Electronics
ULTIMA PRE | Manual
_
You can adjust the input gain on
you input devices so that you can
align the volume levels of your
dierent inputs. There are six
settings, which are x0.50, x1.00,
x1.50, x2.00, x2.50 and x3.00.
6.1 Gain
Gain 6.1
33 // 34
Gain display: Once you have
adjusted the gain setting on an
input device your amplifier will
remember the setting on booting
up the system in the future.
The six available gain settings
are shown below as they are
displayed on the ULTIMA PRE.
Gain on Bus A inputs: Select
your desired input on the
remote control and then press
BUS A. The display will show
the currently selected gain
for this input. Press the VOL
+ to increase gain or VOL - to
decrese.
Gain on Bus B inputs: Select
your desired input on the
remote control and then press
BUS B. The display will show
the currently selected gain
for this input. Press the VOL
+ to increase gain or VOL - to
decrese.
NOTE: When using
a Chord Electronics
DAC please set the
line gain to 0.5.