Wound Component EST Scanner 19035/19035-M/19035-S
Quick Start Guide
1. Preface
1.1 Product Overview
This automatic Wound Component EST (Electrical Safety Test) Scanner is
an equipment designed to perform the tests of AC/DC Hipot, IR (Insulation
Resistance) and Impulse Winding automatically for wound components.
It has AC5kV/DC6kV high voltage output that meets the withstand voltage
test requirement of wound components for outputting maximum current up
to AC 30mA/DC 10mA. Its IR insulation resistance ranged from 0.1MΩ to
50GΩ with voltage output up to 5kV is able to test if the insulation
resistance of wound components meets the standard. In addition to
measuring the electrical characteristic of wound components, the DC
resistance test can also check the connection before performing the safety
withstand voltage test.
The EST Scanner uses a clear display to show all settings, time, current,
voltage, resistance and memory no., etc without the need to memorize the
parameters set beforehand.
The 19035 Wound Component EST Scanner has equipped the device to
identify pass or fail products as well as to output signals of test result and to
remote control other devices. It has RS232 interface that is of advantage
to automatic test system with optional GPIB/HANDLER interface available
for selection. This EST Scanner equipped with assorted devices
mentioned above is capable of performing highly efficient and accurate
tests for wound components.
1.2 Features
■ Diverse Tests
The 19035 Wound Component EST Scanner is able to use the test
functions such as Withstand Voltage test for AC (WVAC), Withstand
Voltage test for DC (WVDC), Insulation Resistance (IR) test, DC
Resistance (DCR) test and Open/Short Check separately.
1
To Next Page
Loading...
