Need help?Do you have a question about the Chroma 11210 and is the answer not in the manual?
General| Type | Video Pattern Generator |
|---|---|
| Power Supply | 100-240VAC, 50/60Hz |
| LVDS | Yes |
| Display | LCD |
| Interface | USB, RS-232 |
General introduction to the Chroma 11210 Battery Cell Insulation Tester.
Key specifications of the Chroma 11210 Battery Cell Insulation Tester.
Instructions for inspecting the instrument upon receipt and checking accessories.
Detailed specifications for Leakage Current (LC) testing.
Details on the various interface options available for the instrument.
Information about optional Partial Discharge (PD) testing functions.
Other specifications including power, environment, dimension, and weight.
General safety precautions and warnings for using the instrument.
Guidelines for suitable operating and storage environments to ensure performance.
Instructions for correctly connecting the instrument to the power supply.
Information on fuse specifications and replacement procedures.
Recommendation for using a voltage regulator to ensure accuracy.
Detailed steps for connecting the DUT for leakage current testing.
How to adjust the LCD display's contrast and brightness settings.
Procedures for managing files, including saving, opening, and deleting.
How to check the instrument's firmware and model version.
Description and labeling of the instrument's front panel controls and indicators.
Description and labeling of the instrument's rear panel connectors and components.
Overview of the main menu options for configuring instrument functions.
Accessing and configuring system-level settings and options.
Setting up and performing insulation resistance (IR) and leakage current (LC) tests.
Performing WV (Voltage/Current) tests.
Explaining various warning and protection functions of the instrument.
Setup for IR/LC measurements with the PD Tester card.
LC Null function for the PD Tester card.
Contact Check function for the PD Tester card.
Compare function for PD tests.
Display of PD test parameters and judgment settings.
Displaying results from PD tests.
Setting IR/LC test conditions for PD Analyzer card.
LC Null function for PD Analyzer card.
Contact Check function for PD Analyzer card.
Compare function for PD Analyzer.
Display of PD Analyzer parameters and judgment settings.
Displaying results from PD Analyzer.
How to connect the kit for PD simulation tests.
Description of the PD Test Checking Kit's front and rear panels.
An example of integrating the kit with the tester for a test.
Technical specifications for the Handler interface.
A table summarizing handler interface signal results.
Examples of external control circuits using the Handler interface.
Timing diagrams for signals on the Handler interface.
Description of data formats used in SCPI commands.
A list of available SCPI commands.
Detailed descriptions of SCPI commands.
Required test equipment for specification verification.
Verification procedure for DCV output and measurement.
Verification procedure for DCA constant current source.
Verification procedure for leakage current measurements.
To Next Page
