Battery Cell Insulation Tester 11210 User’s Manual
5-38
When settings are modified by the above parameters, they will automatically be saved.
Touching the icon at the upper right corner as the figure shown below can enter into File
Management to save the set parameters and load the setting files. See section 3.8 for
detailed description.
5.4.2 Contact Check
See section 5.3.5 for contact check setting.
5.5 Warning Function
5.5.1 OTP Protection
The temperature of outlet is over 80°C and the over temperature warning message as below
figure shows. The tester can’t be operated and outputted at the same time, only can power off
and wait the temperature dropped to power on again.
Time
To Next Page
Loading...
