Setting for Operation
5-19
The calibration data should be displayed as PASS. If it is displayed as
FAIL, please contact the distributor to send the tester for calibration.
5.3 Insulation Test
Insulation resistance tester can apply manual or remote mode for operation. Remote mode
performs the control via HANDLER, LAN, RS-232 or USB (B-Type) interface. Remote mode
related commands will be explained in chapter 9 and 10. The chapter will describe manual
mode to input test condition and process operation via touch panel, and make sure the
resistance of DUT.
5.3.1 LC/IR Parameter Setup
Select “IR/LC Compare” in main menu to enter Edit Parameter Page.
Measurement result displays IR measurement value if IR option is selected, measurement
result displays LC measurement value if LC option is selected.
To Next Page
Loading...
