What Does This Warranty Not Cover? This warranty does not cover any damage or defect that
results from misuse, abuse or modification of the Product other than by Delphi Automotive.
Foam earpieces, which will wear over time through normal use, are specifically not covered
(replacement foam is available for a nominal charge). DELPHI AUTOMOTIVE IS NOT
LIABLE FOR ANY INJURIES OR DAMAGES TO PERSONS OR PROPERTY RESULTING
FROM THE USE OF, OR ANY FAILURE OR DEFECT IN, THE PRODUCT, NOR IS
DELPHI AUTOMOTIVE LIABLE FOR ANY GENERAL, SPECIAL, DIRECT, INDIRECT,
INCIDENTAL, CONSEQUENTIAL, EXEMPLARY, PUNITIVE OR OTHER DAMAGES
OF ANY KIND OR NATURE WHATSOEVER. Some states and jurisdictions may not allow
the exclusion or limitation of incidental or consequential damages, so the above limitation may
not apply to you. This warranty gives you specific legal rights. You may also have other rights,
which vary from jurisdiction to jurisdiction.
What Will Delphi Automotive Do? Delphi Automotive, at its option, will repair or replace any
defective Product. Delphi Automotive reserves the right to replace any discontinued Product
with a comparable model. THIS WARRANTY IS THE SOLE WARRANTY FOR THIS
PRODUCT, SETS FORTH YOUR EXCLUSIVE REMEDY REGARDING DEFECTIVE
PRODUCTS, AND IS IN LIEU OF ALL OTHER WARRANTIES (EXPRESS OR IMPLIED),
INCLUDING ANY WARRANTY FOR MERCHANTABILITY OR FITNESS FOR A PAR-
TICULAR PURPOSE.
If you have any questions or comments regarding your Delphi Automotive wireless headphones,
please phone 1-888-293-3332.
You may register your Delphi Automotive wireless headphones by phone at 1-888-293-3332.
Disc Menu
When listening to a CD Audio or CD Data disc, pushing the remote control’s arrow buttons will
navigate the cursor on the rear touchscreen for whichever touchscreen is selected.
NOTE:
Inserting a disc into the player will “auto play” the disc if already in the "Disc" source menu on the
rear screens.
Display Settings
When watching a video source, pushing “Settings” icon on the touchscreen activates the
Settings menu. These settings control the appearance of the video on the screen. The factory
default settings are already set for optimum viewing, so there is no need to change these settings
under normal circumstances.
To change the settings, use one of the touchscreens. To reset all values back to the original
settings, select the “Reset to Defaults” then select “YES.”
ELECTRONICS
153
To Next Page
