HEATED/VENTILATED SEATS
Front Heated Seats — If Equipped
The front heated seats control buttons are located within the climate or controls screen of the
touchscreen.
You can choose from HI, LO or OFF heat settings. The indicator lights in each switch indicate the
level of heat in use. Two indicator lights will illuminate for HI, one for LO and none for OFF.
• Press the heated seat button
once to turn the HI setting ON.
• Press the heated seat button
a second time to turn the LO setting ON.
• Press the heated seat button
a third time to turn the heating elements OFF.
If the HI-level setting is selected, the system will automatically switch to LO-level after approxi-
mately 60 minutes of continuous operation. At that time, the display will change from HI to LO,
indicating the change. The LO-level setting will turn OFF automatically after approximately
45 minutes.
NOTE:
• Once a heat setting is selected, heat will be felt within two to five minutes.
• The engine must be running for the heated seats to operate.
Vehicles Equipped With Remote Start
On models that are equipped with remote start, the heated seats can be programmed to come on
during a remote start.
This feature can be programmed through the Uconnect system. Refer to “Uconnect Settings” in
“Multimedia” in the Owner's Manual on the DVD.
WARNING!
• Persons who are unable to feel pain to the skin because of advanced age, chronic illness,
diabetes, spinal cord injury, medication, alcohol use, exhaustion or other physical condition
must exercise care when using the seat heater. It may cause burns even at low temperatures,
especially if used for long periods of time
•
Do not place anything on the seat or seatback that insulates against heat, such as a blanket or
cushion. This may cause the seat heater to overheat. Sitting in a seat that has been overheated
could cause serious burns due to the increased surface temperature of the seat.
GETTING STARTED
54
To Next Page
Loading...
