Tether Strap Attachment
1. Route the tether strap to provide the most direct path for the strap between the anchor and the
child seat.
2. If your vehicle is equipped with adjustable rear head restraints, raise the head restraint, and
where possible, route the tether strap under the head restraint and between the two posts.
If not possible, lower the head restraint and pass the tether strap around the outboard side of
the head restraint.
3. Attach the tether strap hook of the child restraint to the top tether anchorage and remove
slack in the tether strap according to the child restraint manufacturer’s instructions.
Third Row Tether Attachment
The tether anchorage found on the back of the 60% seat in the third row may be used by either
the left outboard or the center seating position. Only tether one child restraint to the tether
anchorage at a time.
To connect the tether strap hook to the tether anchorage for either seating position on the 60%
third row seat:
1. Route the tether strap to provide the most direct path for the strap between the anchor and the
child seat.
2.
If the car seat is in the center, raise or remove the center head restraint and route the tether strap
around the inboard (right) side of the head restraint support posts, as shown in the diagram.
3. Attach the tether strap hook of the child restraint to the top tether anchorage as shown in the
diagram.
4. Remove slack in the tether strap according to the child restraint manufacturer’s instructions.
Center Tether Attachment – 3rd Row
Outboard Tether Attachments – 3rd Row
GETTING STARTED
36
To Next Page
