Obstacle Detection
The system stops when it detects an obstacle. Two short tones sound and the system reverses to
the open or closed position. When you remove the obstacle, you can power open or close the
liftgate.
NOTE:
Entering your vehicle while the liftgate is closing can cause your vehicle to bounce and activate
obstacle detection. To prevent this, let the liftgate close completely before you enter your vehicle.
Before driving off, check the instrument cluster for a liftgate or door open message or warning
indicator. Failure to do this could result in unintentionally leaving the liftgate open while driving.
NOTE:
Disable the Hands-Free Liftgate feature through Uconnect during the following:
• Vehicle Servicing
• Jacking and Tire Changing
KEYLESS ENTER-N-GO — IGNITION
Starting
Perform the following starting procedure with a Remote Keyless Entry (RKE) Key Fob inside the
vehicle:
1. Place the gear selector in PARK or NEUTRAL.
2. While depressing the brake pedal, push the ENGINE START/STOP button once. If the
engine fails to start, the starter will disengage automatically after 10 seconds.
3. To stop the cranking of the engine prior to the engine starting, push the button again.
Stopping
1. Bring the vehicle to a complete stop.
2. Shift the transmission to PARK (P).
3. Push the ENGINE START/STOP button once. The ignition switch will return to the OFF
position.
NOTE:
If the transmission is not in PARK and the vehicle is in motion, the ENGINE START/STOP
button must be held for two seconds with the vehicle speed above 5 mph (8 km/h) before the
engine will shut off.
GETTING STARTED
22
To Next Page
