– Adaptive Cruise Control (ACC) With Target Detected Indicator Light
This light will appear either white or green in the instrument cluster. Depending on which color it
appears, it could mean one of the following:
• White — The Adaptive Cruise Control (ACC) With Target Detected Indicator Light turns on
and is white when the ACC system is on, but set to a specific speed, and a target vehicle is
detected.
• Green — The Adaptive Cruise Control (ACC) With Target Detected Indicator Light turns
from white to green when the ACC system is set to a specific speed, and a target vehicle is
detected.
– Speed Warning Indicator Light
This telltale will illuminate when the Speed Warning feature is turned on and set to a specific
speed. The number displayed will be the same as the specific speed set when the Speed Warning
Feature was turned on. If this speed is exceeded the telltale will change from white to yellow, a
chime will sound for up to 10 seconds, and a message will pop up in the instrument cluster.
Oil Change Required
Your vehicle is equipped with an engine oil change indicator system. The Oil Change Required
message will display in the EVIC/DID display for approximately 10 seconds, after a single chime
has sounded, to indicate the next scheduled oil change interval. The engine oil change indicator
system is duty-cycle based, which means the engine oil change interval may fluctuate dependent
upon your personal driving style.
Unless reset, this message will continue to display each time you turn the ignition switch to the
ON/RUN position or place the ignition in the ON/RUN position if equipped with Keyless
Enter-N-Go — Ignition. To turn off the message temporarily, push and release the MENU
button. To reset the oil change indicator system (after performing the scheduled maintenance),
refer to the following procedure.
1. Without pushing the brake pedal, push the ENGINE START/STOP button and place the
ignition in the ON/RUN position (do not start the engine).
2. Fully depress the accelerator pedal, slowly, three times within 10 seconds.
3. Without pushing the brake pedal, push the ENGINE START/STOP button once to return the
ignition to the OFF/LOCK position.
NOTE:
If the indicator message illuminates when you start the engine, the oil change indicator system did
not reset. If necessary, repeat these steps.
WHAT TO DO IN EMERGENCIES
180
To Next Page
