If the tire pressure is 19 psi (1.3 Bar) or higher:
1. Push the Power Button to turn on Tire Service Kit and inf late the tire to the cold tire inflation
pressure found on the tire and loading information label located in the driver-side door
opening.
NOTE:
If the tire becomes over-inflated, push the Deflation Button to reduce the tire pressure to the
recommended inflation pressure before continuing.
2. Disconnect the Tire Service Kit from the valve stem, reinstall the cap on the valve stem and
unplug from 12 Volt outlet.
3. Place the Tire Service Kit in its proper storage area in the vehicle.
4. Have the tire inspected and repaired or replaced at the earliest opportunity at an authorized
dealer or tire service center.
5. Remove the Speed Limit sticker from the steering wheel after the tire has been repaired.
6. Replace the Sealant Bottle at your authorized dealer as soon as possible. Refer to “Sealant
Bottle Replacement”.
NOTE:
When having the tire serviced, advise the authorized dealer or service center that the tire has
been sealed using the Tire Service Kit.
Sealant Bottle Replacement:
1. Unwrap the power cord.
2. Unwrap the hose.
3. Remove the bottle cover.
4. Rotate the bottle up beyond vertical to release.
5. Pull the bottle away from the Compressor.
NOTE:
• For sealant bottle installation follow these steps reverse order.
• Replacement sealant bottles are available at authorized service centers.
WHAT TO DO IN EMERGENCIES
187
To Next Page
