Center Seat LATCH
This vehicle has 4 lower LATCH anchorages in the third row, rear seat. Anchorages A and B are
used for the right outboard position behind the front passenger (1). Anchorages C and D are
used for the center seating position (2). The left outboard position (3) does not have lower
anchorages. Do not install a child restraint using anchorages B and C. This is not a LATCH
position in your vehicle.
If a child restraint installed in the center position blocks the seat belt webbing or buckle for the
outboard position, do not use that outboard position. If a child seat in the center position blocks
the outboard LATCH anchors or seat belt, do not install a child seat in that outboard position.
WARNING!
• Use anchorages C and D to install a LATCH-compatible child restraint in the center seating
position (2). Do not install a LATCH-compatible child restraint using anchorages B and C.
This is not a LATCH-compatible position in your vehicle.
•
Never use the same lower anchorage to attach more than one child restraint. Please refer to
“Installing The LATCH-Compatible Child Restraint System” for typical installation instructions.
Installing The Child Restraint Using The LATCH Lower Anchors
Never “share” a LATCH anchorage with two or more child restraints.
1. Loosen the adjusters on the lower straps and on the tether strap of the child seat so that you
can more easily attach the hooks or connectors to the vehicle anchorages.
2. Attach the lower hooks or connectors of the child restraint to the lower anchorages in the
selected seating position.
3. If the child restraint has a tether strap, connect it to the top tether anchorage. See below for
directions to attach a tether anchor.
3rd Row Center LATCH Anchorages
GETTING STARTED
34
To Next Page
Loading...
