EN - 41
Counters
The heat pump control continuously indicates the compressor's operating time in hours in the various operating modes.
Parameters indicated by the
symbol can be accessed by the user.
No. Word sequence Counters
310 Compressor operation Operating-hour meter for global compressor operation
312
Cooling mode operation Operating-hour meter for operation in GeoCooling mode (cooling mode)
313
Heating mode operation Operating-hour meter for compressor operation in heating mode
314
Heating element operation Operating-hour meter for authorising operation of the heating elements
315
Absence mode operation Operating-hour meter for compressor operation in absence mode
316
DHW heating operation Operating-hour meter for compressor operation in domestic hot water thermodynamic production
317
Pool heating operation Operating-hour meter for compressor operation in pool heating mode
320 Number of alarm resets Reset counter for alarms occurring on the heat pump
see document
"conguration and list of fault
codes" no. 3989816
321
Number of threshold
volt limit alarms
Counter for THRESHOLD VOLT LIMIT alarms occurring on the heat pump
322
Number of single phase
starter faults
Counter for SINGLE PHASE STARTER faults
323 Number of discharge limit faults Counter for DISCHARGE LIMIT faults
400
Comp_inst_elec_power Compressor instantaneous electrical power
401
Inst heat cap Instantaneous heating capacity
402
Inst_tot_abs_power Instantaneous total absorbed power
403
Inst_tot_aux_power Instantaneous total auxiliary power
410
Heating_elec_energy_met Electrical energy meter in heating mode
411
Ecs_elec_energy_met Domestic hot water mode electrical energy meter
412
Heat_energy_met Heat energy meter
413
Auxiliary_elec_energy_met Auxiliary electrical energy meter
414
Heat elem_elec_energy_met Heating element electrical energy meter
415
Tot_heat_elec_energy_met Heating mode total electrical energy meter
416
Tot_dhw_elec_energy_met Domestic hot water mode total electrical energy meter
417
Tot_heat_energy_met Total heat energy meter
418
Tot_aux_energy_met Auxiliary total electrical energy meter
419
Tot_heat_elem_elec_energy_met Electric heating element total electrical energy meter
No. Word sequence Product reference
450 CPU board version Control board version no.
452 Terminal version Control terminal version no.
460 Expansion board version Expansion board version no. (option management)
470
Serial no. Heat pump serial no.
To monitor the heat pump operating hours and provide optimised management of the operating modes, it is possible to reset the
meters, with the exception of P321.
To do this, simply place the meter in the reset position and press and hold the terminal button for at least 3 seconds. The counter
then reverts to the value
0h.
Product reference
To find out the software version installed on the heat pump, please refer to the reading parameters below:
To Next Page
Loading...