CIAT Xenea 20H - Page 2

HEAT PUMPS - AIR CONDITIONING - REFRIGERATION - AIR HANDLING - HEAT EXCHANGE - NA 12.692 A
XENEA
2
Indoor packaged air-to-water heat pump
Casing
 Casing in RAL 9016 white lacquered steel
 Casing panel in RAL 9016 matching ABS
 Rain guard grille in RAL 9001 lacquered panel and bird screen
 Angle bars in galvanised steel and foam pads for flow separation kit
 Wall rubber bushes and anti-vibration feet
Compressor - R410A
 Hermetic on/off SCROLL on anti-vibration mounts
 Built-in electric motor cooled by suction gas
 Motor protected by internal winding sensor
 Noise insulation
 Crankcase heater
Brazed-plate condenser
 End plates and internal plates in AISI 316 stainless steel
 High-performance, optimised plate patterns
 Thermal insulation
Evaporator
 Coil made of bent copper tubes and aluminium fins
Standard components
 Cycle reversing valve
 Suction accumulator
 Liquid tank
 Pressure-relief expansion valve
 PSU and controller board
Safety components
 HP pressure switches
 LP pressure sensors
 Frost protection sensors (exchanger refrigerant/water outlets)
 Water supply sensor on the exchanger
 Water safety valve (4 bar)
 Short cycle protection
Built-in hydraulic module
 3-speed accelerator pump
 Differential water pressure switch
 8 L expansion vessel
 Manual air bleed valve
 Pressure switch and valve assembly
 Filter valve
 Hydraulic hoses
 Staged auxiliary electric heater
HomeConnect control
 Temperature display
 Wireless external temperature sensor
 Water law configuration
 Monitors the operating and safety settings
 Boiler backup configuration and control
 Optimised defrosting
Electrical panel
 Unit complies with NFC-15100, EN 60-335 and EN 330-220
 Earth connection
Options (for installation on site)
 Charging kit
 DHW kit
 Swimming pool kit
 Floor limiter thermostat kit
COMPOSITION