CILICO CT20 - Code 128

64
3.8 Code 128
Decide whether or not to enable Code 128. The CT20 Scanner defaults enable Code 128.
Note: Read the "Disable Code 128" barcode will make the scanner can not read the
Code 128 barcode. Thus, if the scanner can not read the Code 128 barcode, please trying
to read "Enable Code 128" to reset.
For Example: Disable Code 128
1. Read the "Enter Setup" barcode;
2. Read the "Disable Code 128" barcode;
3. Read the "Exit with Save" barcode.
（*）Enable Code128
Disable Code128
Enter Setup
Exit with Save
Exit without Save