- 9 -
PROCEDURE: PAGE
18) Clean out melter. 24-26
NOTE: When leaving reheatable material in tank, allow the agitator to run until the oil
and material temperatures are the same.
19) Turn the temperature control box off and shut off engine. 15
20) Turn LP bottle(s) off. 13
21) Coil sealing hose and place in cabinets along with wand (Non-heated
hose models only).
22) Lock hose boom in tow position.
23) Always secure sealing wand, sealing hose and hose boom
before towing the melter.
Operating Sequence (LP Units cont.)
To Next Page
Loading...
