- 6 -
Controls and Their Functions
NOTE: This general outline will only familiarize you with the machine. Read through
the entire manual before putting this machine into operation. (Refer to Dia-
gram 1 on page 9)
1) Access Port: The sealing wand is placed in here when not in use. This allows
operator to continue circulating material through the hose to prevent material from
cooling and freezing up.
2) Loading Door Place the material on safety door to load the melting tank.
3) Oil Temperature Gauge: Monitors the heat transfer oil temperature.
4) Material Temperature Gauge: Monitors the heat of the material in the tank.
5) Pressure Valve: This valve controls the flow rate of the material being pumped to
the hose and sealing wand by changing the pressure setting. (Turning the valve
clockwise will increase the pressure which in turn will increase the flow). During
sealing operations, this valve alone can be used to regulate flow.
6) Agitation Drive Control Switch: Flip this toggle switch to the forward-off-reverse
fuction.
7) Pressure Gauge: This gauge measures the pressure required to turn the agitator.
By observing this gauge, the operator can tell if the agitator is rotating.
8) Pump Drive Control Switch: Flip this toggle switch to the forward-off-reverse
fuction.
9) Temperature Control Box: This control allows the operator to set the desired oil
and material temperatures. The setting will be maintained automatically.
10) Wand Holder: On models with the electrically heated hose, the wand is placed into
this holder..
11) PSI Gauge: This gauge will tell you the amount of pressure in the hydraulic system.
12) Ignition: This will allow you to start the engine. (This must be turned on to allow
the machine to start.
To Next Page
Loading...
