Cisco 3200 Series - Page 123

B-5
Cisco 3200 Series Router Hardware Reference
OL-5816-10
Appendix B SFP Module Replacement
Error Message NOT_IDENTIFIED: Detected for transceiver module in %s, module disabled
Explanation The transceiver module for the interface specified in the error message could not be
identified and may not be compatible with the interface. The transceiver module specified in the
error message contains a transceiver code which could not be correctly interpreted. As a result of
the error, the module is disabled.
Recommended Action Replace the module with a compatible transceiver.
Error Message UNSUPPORTED-TRANCEIVER: Unsupported SFP transceiver found on board.
Warranty/support may void
Explanation The transceiver module for the interface specified in the error message is not a Cisco
supported module. As a result of the error, the module is disabled. When Cisco determines that a
fault or defect can be traced to the use of third-party transceivers installed by a customer or reseller,
then, at Cisco's discretion, Cisco may withhold support under warranty or a Cisco support program.
In the course of providing support for a Cisco networking product Cisco might require that the end
user install Cisco transceivers if Cisco determines that removing third-party parts will assist Cisco
in diagnosing the cause of a support issue.
Recommended Action None.