Cisco 3825 - Page 356

Index
IN-4
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
F
figure
asymmetric PWE3 configuration B-2
ATM over L2TPv3 configurations B-48
ATM over MPLS configuration B-41
Cisco 3825 router in a cell site POP 1-6
Cisco 3825 router in a GSM Abis and UMTS Iub
Optimization over IP
1-3
Cisco 3825 router in a PWE3 1-5
Cisco 3825 router in a RAN-O 1-2
Cisco 3825 router port numbers 3-2
Cisco 3825 router VWIC and NM-2W configuration
options block diagram
1-13
clocking example 4-3, 4-4
combined GSM and UMTS configuration B-63
ethernet over MPLS-VLAN and port mode
configuration
B-15
GSM and UMTS with IMA and PVC routing (HSDPA
offload) configuration
B-74
GSM and UMTS with IMA configuration B-68
GSM only configuration B-55
GSM only configuration via satellite B-80
PWE3 over MLPPP configuration B-21
PWE3 redundancy configuration B-30
TDM over MPLS configuration B-36
UMTS only configuration without IMA B-59
first-time configuration 3-1
G
GE interface
configuring 4-8
enabling 4-9
IP address 4-8
labeling 3-2
mode 4-8
speed 4-8
gigabit ethernet
See GE interface
global parameters
configuring 3-4
GSM Abis and UNTS Iub
example of Cisco 3825 router in a GSM Abis and
UMTS Iub optimization over IP (figure)
1-3
gsm-abis congestion abate
set A-21
gsm-abis congestion critical
configure A-23
gsm-abis congestion onset
configure A-27
gsm-abis jitter
configure A-29
GSM-Abis links
configuring 4-20
gsm-abis local
configure A-31
gsm-abis remote
configure A-32
GSM interface
between BTS and BSC 1-1
H
help, Cisco IOS 2-1
hostname
configuring 4-6
verifying 4-7
hot standby router protocol
See HSRP
HSRP
in RAN-O 1-2
I
intelligent cell site IP services 1-5
interface
configuring E1 4-11
GE, configuring 4-8