Set Up a VPN Connection from the Phone Web Page
You can set up a VPN connection from the phone web page.
You can do the same configuration on your phone, see Set Up a VPN Connection , on page 148.
Cisco IP Phone 6821 Multiplatform Phones doesn't support VPN connection.
Procedure
Step 1 On the phone web page, select Voice > System.
Step 2 Under the section VPN Settings, set the parameters described in the following table.
Table 18: VPN Settings
DescriptionParameter
IP address or FQDN of the VPN server.
Default: Empty
VPN Server
Enter a username for a credential user on the VPN
server.
Default: Empty
VPN User Name
Enter a password of the specified username to access
the VPN server.
Default: Empty
VPN Password
Enter a tunnel group assigned to the VPN user.
Tunnel group is used to identify the group policy for
the VPN connection.
Default: Empty
VPN Tunnel Group
Choose whether your phone connects to the VPN
server automatically after the phone reboots.
Default: No
Connect on Bootup
Step 3 Click Submit All Changes to save the changes.
The VPN settings are finished. For information about how to enable the VPN connection, see Enable a VPN
Connection, on page 148.
View the VPN Status
You can check the details of the VPN connection. For example, the current VPN status and VPN IP address
of your phone.
Cisco IP Phone 6800 Series Multiplatform Phones User Guide
150
Settings
Set Up a VPN Connection from the Phone Web Page
To Next Page
Loading...
Need help?
General
