Cisco 6945 User Manual

Adjusting the Handset Rest
You can adjust the handset rest of a wall-mounted phone so that the receiver does not slip out of the cradle.
Procedure
Step 1
Set the handset aside and pull the square plastic tab from the handset rest.
Step 2
Rotate the tab halfway (180 degrees).
Step 3
Hold the tab between two fingers, with the small notches (in the corners) facing you.
Step 4
Make sure the tab lines up evenly with the slot in the cradle.
Step 5
Slide the tab back into the handset rest. An extension protrudes from the top of the rotated tab. Return the
handset to the handset rest.
Cisco Unified IP Phone 6945 User Guide for Cisco Unified Communications Manager Express Version 8.8 (SCCP)
OL-24413-01 7
Overview
Adjusting the Handset Rest

Cisco 6945 Specifications

General

Resolution	320 x 240 pixels
Speakerphone	Yes
Protocols	SIP, SCCP
Ethernet	10/100 Mbps
Power	IEEE 802.3af PoE or optional external power adapter
Audio	Full-duplex speakerphone
Headset Port	Yes, RJ9
Supported Codecs	G.711, G.722, G.729a, iLBC