Contents
5
Cisco 7200 VXR Installation and Configuration Guide
OL-5013-09
Attaching a Chassis Ground Connection 3-17
Connecting Port Adapter Cables 3-19
Connecting I/O Controller, NPE-G1, or NPE-G2 Cables 3-19
Connecting to Gigabit Ethernet Slots and Ports 3-19
Gigabit Ethernet SFP Module Connections 3-20
Mode-Conditioning Patch Cord Description 3-23
Gigabit Ethernet GBIC Connections 3-24
GBIC Cabling and Connection Equipment 3-26
Mode-Conditioning Patch Cord Description 3-28
Gigabit Ethernet RJ-45 Connections on the NPE-G1 and NPE-G2 3-29
Connecting to the I/O Controller Ethernet and Fast Ethernet Ports 3-30
Ethernet and Fast Ethernet RJ-45 Connections 3-30
Fast Ethernet MII Connections 3-33
Connecting to the Console and Auxiliary Ports 3-34
DB-25 Port Cabling and Pinouts 3-35
RJ-45 Port Cabling and Pinouts 3-37
Connecting Power 3-41
Connecting AC-Input Power 3-42
Connecting DC-Input Power 3-42
CHAPTER
4 Observing System Startup and Performing a Basic Configuration 4-1
Checking Conditions Prior to System Startup 4-1
Starting the System and Observing Initial Conditions 4-2
Configuring a Cisco 7200 VXR Router 4-3
Performing a Basic Configuration Using AutoInstall 4-4
Performing a Basic Configuration Using the Setup Facility 4-4
Configuring Global Parameters 4-5
Configuring the Native Gigabit Ethernet Interfaces 4-8
Configuring the Interface Transmission and Speed Modes 4-8
Sample Configuration 4-9
Debugging 4-10
Resetting the Interface on the NPE-G1 or NPE-G2 4-10
Clearing Counters on the NPE-G1 or NPE-G2 4-10
Configuring Port Adapter Interfaces 4-10
Configuring ATM Interfaces 4-10
Configuring Fast Ethernet Interfaces 4-11
Configuring Synchronous Serial Interfaces 4-12
Performing a Basic Configuration Using Global Configuration Mode 4-14
Saving the Running Configuration to NVRAM 4-15
To Next Page
Loading...
