3-3
Cisco 7200 VXR Installation and Configuration Guide
OL-5013-09
Chapter 3 Installing a Cisco 7200 VXR Router
Rack-Mounting a Cisco 7200 VXR Router
Figure 3-1 Typical Four-Post Equipment Rack Posts and Mounting Strips
If you want the port adapter end (the front) of the chassis recessed in the rack, install the rack-mount
brackets at the front or rear of the chassis in the orientation shown in
Figure 3-2. If you want the front
of the chassis protruding from the rack, install the rack-mount brackets at the front or rear of the chassis
in the orientation shown in
Figure 3-3.
1 Rack posts 4 Mounting strips
2 18.31 in. (46.48 cm) hole center-to-center 5 17.00 in. (43.18 cm) minimum
3 110 VAC outlets
To Next Page
Loading...
