Cisco 7600 Series - Page 65

5-3
Cisco 7600 Series Router Module Guide
OL-9392-05
Chapter 5 Multilayer Switch Module
Note Use a paper clip or a small, pointed object to access the CONSOLE PORT MODE switch.
Use the CONSOLE PORT MODE switch as follows:
• Mode 1—Place the switch in the in position (factory default position) to connect a terminal to the
console port using the console cable and DTE adapter (labeled “Terminal”) that shipped with the
router.
You can also use this mode to connect a modem to the console port using the console cable and DCE
adapter (labeled “Modem”) that shipped with the switch.
• Mode 2—Not supported.