EasyManuals Logo

Cisco 7600 Series Module Guide

Cisco 7600 Series
128 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #69 background imageLoading...
Page #69 background image
6-3
Cisco 7600 Series Router Module Guide
OL-9392-05
Chapter 6 Network Analysis Modules
Network Analysis Module (WS-SVC-NAM-2)
The NAM monitors and analyzes network traffic for the Cisco 7600 series routers using remote
monitoring (RMON), RMON extensions for switched networks (SMON), and other management
information bases (MIBs). The NAM supports the following RMON groups:
RMON groups defined in RFC 1757
RMON2 groups defined in RFC 2021
The NAM also can monitor individual Ethernet VLANs, which allows it to serve as an extension to the
basic RMON support provided by the supervisor engine.
You can use any other IETF-compliant RMON application to access link, host, protocol, and
response-time statistics for capacity planning, departmental accounting, and real-time application
protocol monitoring. You also can use filters and capture buffers to troubleshoot the network.
The NAM can analyze Ethernet VLAN traffic from one or both of the following sources:
Ethernet, Fast Ethernet, Gigabit Ethernet, trunk port, or Fast EtherChannel SPAN or RSPAN source
port
For more information about SPAN and RSPAN, refer to the “Configuring SPAN and RSPAN”
chapter in the Cisco 7600 Series Cisco IOS Software Configuration Guide .
Note Cisco IOS software currently does not support RSPAN.
Netflow Data Export (NDE)
For more information about NDE, refer to the Cisco 7600 Series Cisco IOS Software Configuration
Guide .
The NAM-2 module has 1 GB of RAM and a 128 MB capture buffer.
The front panel LEDs are shown in Figure 6-2 and described in Table 6-2.
Figure 6-2 Network Analysis Module (WS-SVC-NAM-2)
Ta b l e 6-2 NAM-2 Module STATUS LED Description
Color/State Description
Green All diagnostic tests pass. The NAM is operational.
Red A diagnostic other than an individual port test
failed.
Orange Indicates one of three conditions:
The NAM is running through its boot and
self-test diagnostic sequence.
The NAM is disabled.
The NAM is in the shutdown state.
Off The NAM is powered off.
NETWORK ANALYSIS MODULE
SHUTDOWN
WS-SVC-NAM-2
STATUS
73753
STATUS LED
SHUTDOWN button

Table of Contents

Other manuals for Cisco 7600 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 7600 Series and is the answer not in the manual?

Cisco 7600 Series Specifications

General IconGeneral
CategoryNetwork Router
Port DensityVaries by module
InterfacesGigabit Ethernet, 10 Gigabit Ethernet
RedundancyPower supplies
Power SupplyAC or DC, Redundant options available
Operating SystemCisco IOS XR
ManagementCLI, SNMP
Form FactorModular
DimensionsVaries by chassis model
WeightVaries by chassis model and configuration
Chassis Slots6, 9, or 13

Related product manuals