Cisco 7600 Series Module Guide

6-4
Cisco 7600 Series Router Module Guide
OL-9392-05
Chapter 6 Network Analysis Modules
Network Analysis Module (WS-SVC-NAM-2)
The SHUTDOWN button is used to manually shut down the NAM. To prevent corruption of the NAM,
it is critical that the NAM run through the shutdown procedure before shutting off. If the NAM fails to
respond to CLI or NAM shutdown commands, you can use the SHUTDOWN button as an alternative
shutdown method.
For information on NAM module hardware and software requirements and port adapter installation and
configuration, refer to the
Catalyst 6500 Series Switch and Cisco 7600 Series Router Network Analysis
Module Release 3.4 Configuration Note.

Cisco 7600 Series Specifications

General

Category	Network Router
Port Density	Varies by module
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet
Redundancy	Power supplies
Power Supply	AC or DC, Redundant options available
Operating System	Cisco IOS XR
Management	CLI, SNMP
Form Factor	Modular
Dimensions	Varies by chassis model
Weight	Varies by chassis model and configuration
Chassis Slots	6, 9, or 13