Send document comments to nexus7k-docfeedback@cisco.com
7-50
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
OL-23435-03
Chapter 7 Configuring vPCs
Configuring vPCs
!Command: show running-config vpc
!Time: Wed Mar 24 18:43:54 2010
version 5.0(2)
feature vpc
logging level vpc 6
vpc domain 5
reload restore
This example shows how to examine the consistency parameters:
switch# show vpc consistency-parameters interface port-channel 1
Legend:
Type 1 : vPC will be suspended in case of mismatch
Name Type Local Value Peer Value
------------- ---- ----------- ---------------
STP Port Type 1 Default -
STP Port Guard 1 None -
STP MST Simulate PVST 1 Default -
mode 1 on -
Speed 1 1000 Mb/s -
Duplex 1 full -
Port Mode 1 trunk -
Native Vlan 1 1 -
MTU 1 1500 -
Allowed VLANs - 1-3967,4048-4093
Local suspended VLANs - - -
Configuring Autorecovery
Beginning with Cisco NX-OS Release 5.2(1), you can configure the Cisco Nexus 7000 Series device to
restore vPC services when its peer fails to come online by using the auto-recovery command.
BEFORE YOU BEGIN
Ensure that you have enabled the vPC feature.
Ensure that you are in the correct VDC (or use the switchto vdc command).
SUMMARY STEPS
1. configure terminal
2. vpc domain domain-id
3. auto-recovery [reload-delay time]
4. exit
5. (Optional) show running-config vpc
6. (Optional) show vpc consistency-parameters interface port-channel number
7. (Optional) copy running-config startup-config
To Next Page
Loading...
Need help?
General
